The console will begin scanning all TV channels. If no broadcast signal is detected on a channel, the channel will be skipped; if a signal is detected, a tone will sound and the channel will be stored in memory. This process will continue until the high- est channel is reached. The lowest channel stored in memory will then appear in the main display.
Press the ENTER AGE/WT button again and
15 delete or add TV channels.
After all valid TV channels have been stored in the console’s memory, you can delete unwanted channels or add other channels. To delete or add
a channel, first press the CHANNEL + and – but- tons until the channel appears in the main display.
Next, press the + or – button beside the ENTER AGE/WT button until the words DELETE or ADD appear in the main display. Then, select the next channel that you want to delete or add. Repeat this process until you have finished deleting or adding channels.
16Hold down the ENTER AGE/WT button and the RESET button simultaneously for two seconds to exit the maintenance mode.
To exit the maintenance mode at any time, hold down the ENTER AGE/WT button and the RESET button simultaneously for two seconds.
HOW TO RESET THE LUBE REMINDER
If the words LUBRICATE DECK appear in the main display when the maintenance mode is selected (refer to step 9 on page 24), follow the steps below to reset the lube reminder.
1 Insert the key into the console.
Refer to GETTING STARTED on page 14.
2 | Hold down the STOP button and the RESET |
button simultaneously for three seconds. |
25
