P REVENTIVE | M AINTENANCE |
Regular maintenance is necessary for the optimal performance and long life of the INCLINE TRAINER. Please read and follow all instructions below. If the INCLINE TRAINER is not maintained as described, components may wear excessively, the INCLINE TRAINER may be damaged, and the warranty will be
voided. If you have questions about maintenance, call Customer Care
through Friday, 8 a.m. until 5 p.m. Mountain Time (excluding holidays).CAUTION: Make sure to remove the key and unplug the power cord before performing any maintenance procedures.
WEEKLY MAINTENANCE
1.Unplug the power cord.Inspect and properly tighten all external parts of the INCLINE TRAINER.
2.Apply a mild
ing belt. | Do not wipe under the walking belt. | Apply a small amount of mild |
cotton cloth and wipe the console and the screens. | Do not spray cleaner directly onto the INCLINE | |
TRAINER or use ammonia or |
| |
3.Make sure that the walking belt is centered and properly tightened. If it is centered and runs smoothly, do not make any adjustments. If the walking belt needs to be adjusted, refer to pages 33 and 34.
MONTHLY MAINTENANCE
1. | Unplug the power cord. | Remove the screws attaching the |
|
| motor hood and lift off the motor hood. Using a |
| |
| vacuum, clean the area under the electronics cover. | Be care- | |
| ful to avoid touching any components. |
|
|
2. | Plug in the power cord and insert the key into the console. |
| |
| Raise the INCLINE TRAINER to the highest incline level. |
| |
| Remove the key and unplug the power cord. | Check the | |
| motor belt for wear and cracks. If the motor belt needs to be re- |
| |
| placed, refer to page 46 to order a new motor belt. |
| |
Motor |
Belt |
Electronics Cover |
3. | Plug in the power cord and insert the key into the console. Press the START button. | Be careful to avoid in- | ||||
| jury; keep your hands away from moving parts and make sure that your clothes cannot become |
|
| |||
| caught in moving parts. |
| While the walking belt is moving, check the motor for arcing. Next, check the IN- |
|
| |
| CLINE TRAINER for unusual noises or odors. If any of these problems exists, call Customer Care |
|
| |||
| Remove the key and unplug the power cord. | Reattach the motor hood with the screws. |
| |||
4. | The walking platform should | not be lubricated before the |
|
|
| |
| INCLINE TRAINER is used. However, lubricant should be |
|
| B | ||
| applied at least once every month. To purchase a lubricant |
|
|
| ||
| pump or lubricant packets, call Customer Care |
|
|
| ||
| CAUTION: Before applying lubricant, |
|
|
| ||
| remove the key and unplug the power cord. | A |
|
| ||
|
|
|
|
| Apply | |
| To use a lubricant pump, |
| first prime the pump. Insert the |
|
| |
|
|
|
| packet | ||
| wand under the walking belt in the location shown by dotted |
| Insert | |||
|
| here | ||||
| line A. Center the nozzles under the walking belt and apply |
| ||||
|
| wand | ||||
|
|
| ||||
| lubricant as you slide the wand forward to dotted line B. Then, |
| here |
| ||
| pull the wand back out. |
| To use lubricant packets, | open one |
|
|
| packet, reach under one side of the walking belt as far as you |
|
|
| ||
| can, and apply the entire packet between dotted line A and dotted line B. Then, apply a second packet under |
|
| |||
| the opposite side of the walking belt in the same way. | After you have applied lubricant using a lubricant |
| |||
pump or lubricant packets, plug in the power cord, insert the key, adjust the speed to 3 mph, and walk on the walking belt for two minutes to spread the lubricant.
29
