Nortel Networks 114200-E manual Where to Go Next

Starting the ARN

Entering n stops the Quick-Start script and returns you to the Technician interface prompt. Entering y allows you to configure another module/port.

When the install script completes, the ARN starts bridging and routing traffic.

8.Ensure that the ARN is successfully connected to your network.

To verify that the ARN is now connected to the network, contact your network administrator. To troubleshoot any problems, your network administrator can refer to Configuring Passport Remote Access.

If you need additional assistance, contact your local Nortel Networks Technical Solutions Center.

Note: After connecting the ARN to the network, you can replace the management console connection with a modem connection to enable remote dial-in access.

Where to Go Next

Use the following table to determine where you want to go next.

For information about	Go to
Operating the ARN	Chapter 3
Configuring the ARN for Netboot and	Appendix A
Directed Netboot
Using Local Boot (the Quick-Start Procedure)	Appendix B
ARN Technical Specifications	Appendix C

114200-E Rev 00 2-15