118 Configuring and managing ports and VLANs
NN47250-500 (Version 03.01)
To configure a port group named server2 containing ports 15 and 17 and add the ports to the default VLAN,
type the following commands:
WSS# set port-group name server2 15,17 mode on
success: change accepted.
WSS# set vlan default port server2
success: change accepted.
To verify the configuration change, type the following command:
WSS# show vlan config
To indicate that the ports are configured as a port group, the show vlan config output lists the port group name
instead of the individual port numbers.

Removing a port group

To remove a port group, use the following command:
clear port-group name name

Displaying port group information

To display port group information, use the following command:
show port-group [name group-name]
To display the configuration and status of port group server2, type the following command:
WSS# show port-grou p name server2
Port group: server2 is up
Ports: 15, 17

Interoperating with Cisco Systems EtherChannel

Load-sharing port groups are interoperable with Cisco Systems EtherChannel capabilities. To configure a
Cisco Catalyst switch to interoperate with a Nortel WSS, use the following command on the Catalyst switch:
set port channel port-list mode on
VLAN
Name Admin VLAN
Tunl Port Status State Affin Port Tag State
1 default Up Up 5 server2 none Up