Appendix A:Troubleshooting a WSS 775
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Mark messages are disabled by default. When they are enabled, WSS Software generates a message at the notice level
once every 300 seconds by default.
To enable mark messages, use the following command:
WSS# set log mark enable
success: change accepted.

Saving trace messages in a file

To save the accumulated trace data for enabled traces to a file in the WSS’s nonvolatile storage, use the following
command:
save trace filename
To save trace data into the file trace1 in the subdirectory traces, type the following command:
WSS# save trace traces/trace1

Displaying the log configuration

To display your current log configuration, type the following command:
WSS# show log config
Logging console: enabled
Logging console severity: INFO
Logging sessions: enabled
Logging sessions severity: INFO
Logging buffer: enabled
Logging buffer severity: ERROR
Logging trace: enabled
Logging trace severity: DEBUG
Logging buffer size: 1048576 bytes
Log marking: disabled
Log marking severity: NOTICE
Log marking interval: 300 seconds
Logging server: 172.21.12.19 port 514 severity EMER GENCY
Current session: disabled
Current session severity: INFO