258 Configuring APs

NN47250-500 (Version 03.01)

Figure 8. Example Nortel network

To configure APs, perform the following tasks, in this order:

Specify the country of operation.

Configure AP access ports, AP connections, and dual homing.

If required, configure radio-specific parameters, which include the channel number, transmit power, and

external antenna model.

Note. You do not need to set channels and power if you use Auto-RF to set

these values. You do not need to specify an external antenna model unless a radio

uses an external antenna.

However, if you do install an external antenna, you must ensure that the external

antenna model parameter you specify exactly matches the external antenna that is

attached to the AP’s external antenna port, in order to meet regulatory

requirements.

2330
Router
Router
Wired
authentication
client
System IP address
10.10.10.4
2330
Port
1
Port
2
Port
4
WSS1
10.10.40.19/24
10.10.20.19/24
10.10.30.19/24
RADIUS
servers
10.10.70.20
10.10.70.40
10.10.60.18/24
10.10.60.19/24
WMS
Port
3
2330
Layer 2
2330
System IP address
10.10.40.4
WSS2
Layer 2
2330
10.10.10.19/24
System IP address
10.10.50.4
WSS3
Port
5
VLANs on WSS1
VLAN 2 mgmt, port 5, 10.10.10.4/24
VLAN 4 blue, port 5, tag 20, 10.10.20.2/24
VLAN 3 red, port 5, tag 30
Layer 2
serial-id 0322199998
serial-id 0322199999
serial-id 0322199997
serial-id 0322199996
serial-id 0322199995 10.10.50.19/24
external antenna
model 5303