Configuring APs 343
Nortel WLAN—Security Switch 2300 Series Configuration Guide

Displaying connection information for APs

To display connection information for APs configured on a WSS, use the following command:
show ap global [ap-num | serial-id serial-ID]
This command lists the System IP addresses of all the WSS switches on which each AP is configured, and lists the bias
for the AP on each switch. For each AP that is configured on the switch on which you use the command, the connection
number is also listed.
Connections are shown only for the APs that are configured on the WSS from which you enter the command, and only
for the Mobility Domain the switch is in.
To display connection information for all APs configured on a WSS, type the following command:
WSS# show ap global
Total number of ent ries: 8
- 0321500120 10.4.3.2 HIGHThis command indicates that four Distributed APs are configured on the WSS, with
serial IDs 11223344, 332211, 0322100185, and 0321500120. Each AP is also configured on one of two other WSSs,
with system IP addresses 10.3.8.111 and 10.4.3.2. The bias for the AP on each WSS is listed. Normally, a Distributed
AP boots from the WSS with the high bias for the AP. (For more information, see “Resiliency and dual-homing options
for APs” on page 263 and “Boot process for distributed APs” on page 268.)
The ap field indicates the connection number of each AP on the WSS on which the command is typed. A hyphen ( - ) in
the ap field indicates that the AP is configured on another WSS in the same Mobility Domain.
ap Serial Id WSS IP Address Bias
1 11223344 10.3.8.111 HIGH
- 11223344 10.4.3.2 LOW
2 332211 10.3.8.111 LOW
- 332211 10.4.3.2 HIGH
17 0322100185 10.3.8.111 HIGH
- 0322100185 10.4.3.2 LOW
18 0321500120 10.3.8.111 LOW