756 Managing system files
NN47250-500 (Version 03.01)

Specifying a backup configuration file

In the event that part of the configuration file is invalid or otherwise unreadable, WSS Software stops reading informa-
tion in the configuration file and does not use it. You can optionally specify a backup file to load if WSS Software
cannot load the original configuration file.
To specify a backup configuration file, use the following command:
set boot backup-configuration filename
To specify a file called backup.cfg as the backup configuration file, use the following command:
WSS# set boot backup-configuration backup.cfg
success: backup boot config filename set.
After enabling this feature, you can specify that a backup configuration file not be used by entering the following
command:
WSS# clear boot backup-config
success: Backup boot config filename was cleared.
To display the name of the file specified as the backup configuration file, enter the show boot command. For example:
pubs# show boot
Configured boot version: 4.1.0.60
Configured boot image: boot0:mx040100.020
Configured boot configuration: file:configuration
Backup boot configuration: backup.cfg
Booted version: 4.1.0.60
Booted image: boot0:mx040100.020
Booted configuration: file:configuration
Product model: WSS