May 2003 | Preparing for installation |
Inspecting the server interior
Introduction
You should perform a visual inspection for loose components, foreign matter, or shipping damage inside the server.
CAUTION
Risk of equipment damage
When working with interior components, use an ESD wrist strap to protect
To inspect the server interior
1Carefully check all the cards to ensure they are fully seated on the baseboard.
2Check for any loose wires or foreign objects, such as loose screws, inside the chassis.
3Review the slot locations (see “Slot definition and slot numbering” on page 14).
4Do one of the following:
IF | THEN |
|
|
you observe any damage | contact your Nortel Networks |
| technical support representative. |
components have become loose
secure them.
Refer to the procedures in Part 5 of the CallPilot Installation and Configuration binder.
Part 2: 1001rp Server Hardware Installation | 35 |
