Nortel Networks P0605618, 555-7101-217 manual To start the server

Installing the server and connecting the peripheral devices Standard 1.0

2Connect the other end of the DC power cable to the Power Distribution Unit (PDU). See details below:

The following photograph shows the keyed plug of the DC power cable. This plug connects to the PDU:

Note: If you are not using a Nortel Networks-supplied PDU, snip this plug and connect the cable appropriately to your DC power plant. Remember that a red cable is positive, a black cable is negative, and a green cable is the ground.

3Turn on the PDU.

To start the server

1Press the server’s power switch to start the server.

2Observe the Power-On Self-Test (POST) and initialization messages on the monitor.

3When the following menu appears on the monitor, select option 1 to boot Windows NT:

Select one of the following:

---------------------------

1 Windows NT 4.0 Server (Default within 30 secs)

2 Windows NT 4.0 Server (VGA mode) Choose an option[1,2]?1

The Windows NT startup sequence begins.

4Ensure that the Windows NT logon window appears on the monitor.

Note: If the Windows NT logon window does not appear, refer to Part 5 of the CallPilot Installation and Configuration binder for troubleshooting instructions.

72 CallPilot