Nortel Networks P0605618, 555-7101-217 manual To connect the 1001rp AC server to power

Installing the server and connecting the peripheral devices Standard 1.0

To connect the 1001rp AC server to power

CAUTION

Risk of personal injury and hardware failure

The power outlets that are used by the CallPilot server and its peripheral devices must be connected to the same single-point ground reference as the one used by the Meridian 1 switch or Succession CSE 1000 system. If this requirement is not met, power transients can cause personal injury and/or hardware failure.

1Plug the server’s AC power cord into the server’s rear panel.

2Plug the other end of the server’s AC power cord into a properly grounded power outlet or power bar.

70 CallPilot