May 2003 | Installing the server and connecting the peripheral devices |
Requirements
For installation, you require a Phillips No. 1 screwdriver.
To install the software feature key adapter
1Ensure that there is no cable connected to the parallel port.
Note: The parallel port is also known as the printer port or LPT1. It is located at the back of the server. See the diagram on page 59.
2Plug the male end of the adapter into the parallel port.
3Tighten the connector screws.
What’s next?
Continue with “Connecting the server to power” on page 68.
Part 2: 1001rp Server Hardware Installation | 67 |
