3.2.13 Ramp & Soak Menu
Alarm must be DISABLED if Ramp is ENABLED.
It is required that you put the controller in the Standby Mode for any configuration change other than Set Points & Alarms.
Figure 3.11 Flow Chart for Ramp and Soak Menu
ENTER RAMP AND SOAK MENU:
Press a
Press d
Press a
1)Press a, if necessary, until CNFG prompt appears.
2)Display advances to INPT Input Menu.
3)Press a, if necessary, until Display advances to RAMP Ramp and SOAK Soak Menu.
RAMP ENABLE/DISABLE SUBMENU:
Press d
Press b Press d
4)Display advances to “Ramp Enable/Disable” Submenu and flashes ENBL or DSBL.
5)Scroll through the available selections: “Enable” or “Disable”.
6)Display shows STRD stored message momentarily and then advances to SOAK Soak Enable/Disable Menu.
If RAMP Disable was selected, display skips to the next menu item (ID Code).
46
