BUTTON SELECTION SUBMENU:
Press d 12) Display flashes previous selection of GROS Gross or PEAK Peak.
Press b 13) Scroll through the available selection GROS or PEAK to the selection of your choice.
Press d 14) Display shows STRD stored message momentarily and then advances to RDG Reading Configuration Menu.
If GROS was selected, in the Run Mode pressing b button causes the display to flash Gross value (value measured without zeroing of the display).
If PEAK was selected, in the Run Mode pressing b button causes the display to flash Peak value.
0 - 20 mA current input used for process control only.
For 4 - 20 mA Input select 0 - 20 mA and adjust the Input/Reading accordingly. To adjust 4 - 20 mA input, see example under INPUT/READING Submenu.
3.2.5 Reading Configuration Menu
It is required that you put the controller in the Standby Mode for any configuration change other than Set Points & Alarms.
Figure 3.4 Flow Chart for Reading Configuration Menu
19
