ALARM 2 DISPLAY COLOR SUBMENU:
Press d
Press b
Press d
11)Display flashes previous selection for “Alarm 2 Color Display”.
12)Scroll through the available selections: GRN, RED or AMBR.
13)Display shows STRD stored message momentarily and then
momentarily shows the software version number, followed by RST Reset, and then proceeds to the Run Mode.
IN ORDER TO DISPLAY ONE COLOR, SET THE SAME DISPLAY COLOR ON ALL THREE SUBMENUS ABOVE.
If user wants the Display to change color every time that both Alarm 1 and Alarm 2 are triggered, the Alarm values should be set in such a way that Alarm 1 value is always on the top of Alarm 2 value, otherwise value of Alarm 1 will overwrite value of Alarm 2 and Display Color would not change when Alarm 2 is triggered.
Example 1:
Output 1 & Output 2: SSR
Alarm Setup: Absolute, Above, Alarm 2 HI Value “ALR.H” = 200, Alarm 1 HI Value “ALR.H” = 400
Color Display Setup: Normal Color “N.CLR” = Green, Alarm 1 Color “1.CLR” = Amber, Alarm 2 Color “2.CLR” = Red
Display Colors change sequences:
GREEN |
| RED |
|
| AMBER |
➤ | |||||
0 | AL2.H = 200 | AL1.H = 400 |
| ||
Example 2: |
|
|
|
|
|
Output 1 & Output 2: Pulse |
|
|
| ||
Alarms Setup: Absolute, Below, Alarm 2 Low Value “ALR.L” = 300, | |||||
Alarm 1 Low Value “ALR.L” = 100 |
|
|
| ||
Color Display Setup: "N.CLR" = Green, "1.CLR" = Amber, "2.CLR" = Red | |||||
Display Colors change sequences: |
| ||||||
• |
| AMBER |
| RED |
|
| GREEN |
|
|
|
| ||||
0 |
| AL1.L = 100 |
| AL2.L = 300 |
| ||
57
