Onkyo TX-NR905 Speaker Level Calibration, Press the Receiver Remote Mode button, and then use

Advanced Setup—Continued

Note:

5

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Unit,” and then use the Left and Right [ ]/[ ] buttons to select:

feet: Select if you want to enter distances in feet. Can be set from 0.5 to 30 feet in 0.5-foot steps.

meters: Select if you want to enter distances in meters. Can be set from 0.15 to 9 meters in 0.15-meter steps.

•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.

Speaker Level Calibration

These settings are set automatically by the Automatic Speaker Setup function (see page 61).

With the Level Calibration settings, you can adjust the level of each speaker while listening to the test tone so that the volume of each speaker is the same at the listen- ing position. You can adjust the levels of front Speakers

6

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select a speaker, and use the Left and Right [ ]/[ ] buttons to specify the distance.

Specify the distance from the speaker to your listening position.

Notes:

• You can specify different distances

for front Speakers A and front Speak-

ers B, but not the other speakers (i.e.,

subwoofer, center, surround, and sur-

round back).

• The Center distance cannot be set if

the currently selected speakers

(Speakers A or Speakers B) is set to

BTL (page 51), or Center is set to

None (page 94) or Not Use

(page 97).

• The Surr Right and Surr Left dis-

tances cannot be set if the currently

selected speakers (Speakers A or

Speakers B) is set to BTL (page 51),

or Surround is set to None (page 94)

or Not Use (page 97).

• The Surr Back R and Surr Back L

distances cannot be set if Speaker

A and front Speakers B independently. The other speak- ers (i.e., subwoofer, center, surround, and surround back) use the same level settings for Speakers A and Speakers B.

Note:

•The test tone is output at the standard level for THX, which is 0 dB (absolute volume setting 82). If you nor- mally listen at volume settings below this, be careful because the test tone will be much louder.

1Press the [RECEIVER] REMOTE MODE button, and then use the

	RECEIVER	remote controller’s [SP A] or
		[SP B] button to select Speakers
		A or Speakers B, respectively.
		Note:
		• Speakers B cannot be selected if
SP A	SP B	Speaker Type Front B is set to Not
		Use.

2	Press the [SETUP] button.
ET	The main menu appears onscreen.
S	UP

Type Front A or Front B is set to Bi-

Amp or BTL (page 51), Surr Back is

set to None (page 94) or Not Use

(page 97), or Powered Zone 2 is

being used (page 121).

• The Subwoofer distance cannot be

set if Subwoofer is set to No

(page 95).

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings 2.Speaker Config 3.Speaker Distance 4.Level Calibration 5.Equalizer Settings 6.THX Audio Setup

7	Repeat step 6 for each speaker.
8	Press the [SETUP] button.
	Setup closes.
	S
	E
	T
	UP

99