Onkyo TX-NR905 Turn on the AV receiver, Connected TV, Place the setup microphone at, Jack, Appear

First Time Setup—Continued

The onscreen menus shown in this manual may be slightly different from what you see on your TV.

1	Turn on the AV receiver and the
	connected TV.
	On the TV, select the input to which the
	AV receiver is connected.
2	Place the setup microphone at
	the 1st measurement position,
	SETUP MIC and connect it to the SETUP MIC
	jack.
	Auto Speaker Setup
	Next
	Please place microphone at center
	of listening area at ear height.
	Notes:
	• Make sure the microphone is hori-
	zontal.
	• If there’s an obstacle between the
	microphone and any speaker, the
	automatic setup will not work cor-
	rectly. Set up the room as you would
	when enjoying a DVD movie.
	• Positioning the microphone close to
	where your ears would normally be
	will provide the best results. You can
	set the height of the microphone by
	using a tripod or level table.
3	Press [ENTER].
	Auto Speaker Setup
	ENTER
	Do not unplug
	microphone.
	Please keep quiet.
	Now Measuring...

A test tone is output by each speaker in turn, as Audyssey MultEQ XT deter- mines which speakers are connected. This takes a few minutes.

Note:

•If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so keep quiet.

4	The speaker detect results
	appear.
ENTER	Auto Speaker Setup
	Next
	Retry
	Cancel
	:Yes	:No
ENTER		SP Detect Result

“Yes” means that the speaker was detected. “No” means that no speaker was detected.

If you agree with the results, use the Up and Down []/[ ] but- tons to select Next, and then press [ENTER].

The options are:

Next: Proceed to the next step. Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker

setup.

5		The following screen appears.
		Auto Speaker Setup
		Next
		Please place microphone at
		2nd Position at ear height.
		Place the setup microphone at
	ENTER	the next position (see page 61),
		and then press [ENTER].
		Audyssey MultEQ XT performs more
		measurements. This takes a few min-
		utes.
		Auto Speaker Setup
		Do not unplug
		microphone.
		Please keep quiet.
		Now Measuring...

6	When prompted, place the setup
	microphone at the next position,
	and repeat step 5.

62