Onkyo TX-NR905 instruction manual THX Audio Setup, Advanced Setup—Continued, Setup closes, Notes

Advanced Setup—Continued

7

ENTER

ENTER

Use the Up [] button to select “Channel” again, and use the Left and Right []/[ ] buttons to select another speaker.

Repeat steps 6 and 7 for each speaker.

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings 2.Speaker Config 3.Speaker Distance 4.Level Calibration 5.Equalizer Settings 6.THX Audio Setup

3

Use the Up and Down []/[ ] buttons to select “6. THX Audio

8	Press the [SETUP] button.
	Setup closes.
	S
	E
	T
	UP

Notes:

ENTER

ENTER

Setup,” and then press [ENTER].

The THX Audio Setup screen appears.

2-6.THX Audio	Setup
Surr Back Sp	Spacing	1ft-4ft
THX Subwoofer		Yes
BGC		Off

•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.

•The Equalizer settings have no effect on 176.4/ 192 kHz input signals.

THX Audio Setup

These settings are not set automatically by the Auto- matic Speaker Setup function (see page 61).

With the Surr Back Sp Spacing setting, you can specify the distance between your surround back speakers. This setting is used by Speakers A and Speakers B.

If you’re using a THX-certified subwoofer, set the THX Subwoofer setting to Yes. You can then apply THX’s Boundary Gain Compensation (BGC) to compensate the perceived exaggeration of low frequencies for listeners sitting very close to a room boundary (i.e., wall).

1	Press the [RECEIVER] REMOTE
	MODE button, followed by the
RECEIVER	[SETUP] button.
	The main menu appears onscreen.
S
E
T
UP

4	Use the Up and Down [ ]/[ ]
	buttons to select “Surr Back Sp
	Spacing,” and use the Left and
	ENTER
	Right [ ]/[ ] buttons to specify
	the distance between your sur-
	round back speakers:
	< 1 ft (< 0.3 m) (Default): Select this if
	your surround back speakers are
	between 0 and 1 foot (0–30 cm) apart.
	ENTER
	1–4 ft (0.3–1.2 m): Select this if your
	surround back speakers are between 1
	and 4 feet (0.3–1.2 m) apart.
	>4 ft (>1.2 m): Select this if your sur-
	round back speakers are more than 4
	feet (1.2 m) apart.

Note:

•Cannot be set if Surr Back Ch is set to 2ch (page 95), Speaker Type Front A or Front B is set to Bi-Amp or BTL (page 51), SurrBack is set to None (page 95) or Not Use (page 97), or Powered Zone 2 is being used (page 121).

102