Onkyo TX-NR905 instruction manual Advanced Setup, Speaker Setup, Speaker Settings

Advanced Setup

Speaker Setup

This section explains items on the Speaker Setup menu.

Some of the speaker settings are set automatically by the Automatic Speaker Setup function (see page 61).

1	Press the [RECEIVER] REMOTE
	MODE button, and then use the
RECEIVER	remote controller’s [SP A] or
	[SP B] button to select Speakers
	A or Speakers B, respectively.
	Note:

		INPUT SELECTOR
		MACRO
	1		2			3			ZONE3
		REMOTE MODE
	DVD	VCR			CD				ZONE2
					CDR/MD/DOCK
	TV	CABLE			NET/USB				RECEIVER
		SAT							TAPE/AMP
	DIMMER								SLEEP
				ENU	M	EN
			M				U
		OP
		T
ENTER	+
	CH
				ENTER					VOL
	DISC
	ALBUM
	-		G
				UIDE	IT
SETUP	PREV				EX
		SE	TUP					N
	CH				RETU
	DISPLAY								MUTING

RECEIVER

		• Speakers B cannot be selected if
SP A	SP B	Speaker Type Front B is set to Not
		Use.
2		Press the [SETUP] button.
		The main menu appears onscreen.
	S
	E
	T
	UP

REC	PLAYLIST	RANDOM
SP A	SP B
LISTENING MODE

3

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

Speaker Settings

See “Speaker Settings” on page 51.

Speaker Configuration

These settings are set automatically by the Automatic Speaker Setup function (see page 61).

ENTER

ENTER

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings 2.Speaker Config 3.Speaker Distance 4.Level Calibration 5.Equalizer Settings 6.THX Audio Setup

With the Speaker Configuration settings, you can specify which speakers are connected and a crossover frequency, distance, and level for each speaker.

You can choose which of the speakers you want to use with the Speakers A and Speakers B configurations, and set the crossover frequencies, distances, and levels of the front Speakers A and front Speakers B independently.

The other speakers (i.e., subwoofer, center, surround, and surround back) use the same crossover frequencies, distances, and levels for Speakers A and Speakers B.

The following crossover frequencies can be specified: Full Band, 40 Hz, 50 Hz, 60 Hz, 70 Hz, 80 Hz (THX), 90 Hz, 100 Hz, 110 Hz, 120 Hz, 130 Hz, 150 Hz, or 200 Hz.

Specify Full Band for speakers that can output low-fre- quency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover fre- quency will then be output by the subwoofer instead of the speaker. Refer to your speakers’ manuals to deter- mine the optimum crossover frequencies.

If you’re using THX-certified speakers, specify 80 Hz (THX) for all speakers.

4

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Config,” and then press [ENTER].

The Speaker Config screen appears.

2-2.Speaker Config

Speakers A

Subwoofer		Yes
Front	Full Band
Center		100Hz
Surround		100Hz
Surr Back		100Hz
Surr Back Ch		2ch
LPF of LFE		120Hz
Double Bass		On

94