Advanced Setup—Continued
5
ENTER
ENTER
Use the Up and Down [ ]/[ ] buttons to select “Subwoofer,” and then use the Left and Right []/[ ] buttons to select:
Yes: Select if a subwoofer is con- nected.
No: Select if no subwoofer is con- nected.
Note:
•The same setting is used for Speakers A and Speakers B.
8
ENTER
ENTER
Use the Up and Down [ ]/[ ] buttons to select “Surround,” and then use the Left and Right
[]/[ ] buttons to select a crossover frequency.
If no surround left and right speakers are connected, select None.
Notes:
• | The same setting is used for Speakers |
| A and Speakers B. |
• | Cannot be set if the currently |
| selected speakers (Speakers A or |
| Speakers B) is set to BTL (page 51). |
6
ENTER
Use the Up and Down [ ]/[ ] buttons to select “Front,” and then use the Left and Right
[]/[ ] buttons to select a
• Cannot select Full Band if Front |
(step 6) is set to anything other than |
Full Band. |
ENTER
crossover frequency.
Notes:
•This setting can be set independently for front Speakers A and front Speak- ers B.
•Fixed at Full Band if Subwoofer (step 5) is set to No.
9
ENTER
ENTER
Use the Up and Down [ ]/[ ] buttons to select “Surr Back,” and then use the Left and Right []/[ ] buttons to select a crossover frequency.
If no surround back speakers are con- nected, select None.
Notes:
• The same setting is used for Speakers |
7
ENTER
ENTER
Use the Up and Down [ ]/[ ] buttons to select “Center,” and then use the Left and Right
[]/[ ] buttons to select a crossover frequency.
If no center speaker is connected, select None.
Notes:
• The same setting is used for Speakers |
A and Speakers B. |
A and Speakers B. |
• Cannot be set if Speaker Type Front |
A or Front B is set to |
(page 51), Surround is set to None |
(step 8), or Powered Zone 2 is being |
used (page 121). |
• Cannot select Full Band if Surround |
(step 8) is set to anything other than |
Full Band. |
• Cannot be set if the currently |
selected speakers (Speakers A or |
Speakers B) is set to BTL (page 51). |
• Cannot select Full Band if Front |
(step 6) is set to anything other than |
Full Band. |
• For Speakers B, if any channel is set |
to Full Band, Center is fixed at Full |
Band. |
10
ENTER
ENTER
Use the Up and Down [ ]/[ ] buttons to select “Surr Back Ch,” and then use the Left and Right []/[ ] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right) surround back speakers are connected.
Notes:
•The same setting is used for Speakers A and Speakers B.
•Cannot be set if Speaker Type Front A or Front B is set to
Continue with step 11 on the next page.
95