UG_Proview_6937500100.qxd 7/09/04 18:13 Page 1
PACKARD BELL MONITOR QUICK START GUIDE
SAFETY AND MAINTENANCE INSTRUCTIONS
To reduce the risk of fire or electric shock, do not expose this monitor to rain or moisture. Place the monitor on a steady surface where it is not likely to fall.
To reduce eye fatigue, avoid using the monitor in direct sunlight or under bright lights.
To prevent electric shock do not remove screws or cover. Never open the monitor! There are no
Input power source: In many European countries, the wall outlets are 230V, in a range from 200 to 240V. Please check if your monitor supports your country's voltage.
Do not place anything heavy on the power cord or any other cables. A Damaged power cord may cause fire or electric shock. If your power cord is damaged, do not use it. A replacement can be purchased at your local computer or electronics store. Do not disassemble the monitor. The cover should be removed by qualified service personnel only.
Keep children and pets away from the monitor. Do not allow liquids to spill into the cabinet.
Do not operate the monitor beyond the specified temperature and humidity range. For proper operation, keep the monitor adequately ventilated.
Keep the monitor away from strong magnetic fields produced by transformers, motors, fans, or other devices.
When an irregular AC Voltage is supplied, a protective circuit may turn off the monitor (the power indicator will also go off). If this happens, turn off the power switch and wait at least 30 seconds before turning it on again.
INSTALLATION INSTRUCTIONS (SEE THE ILLUSTRATIONS AT THE START OF THIS GUIDE)
1.Make sure your computer and monitor power are OFF. A VGA video signal cable has been delivered with your monitor.
Carefully connect one of its
2.Connect the power supply to the monitor, using the corresponding illustration (page 2) as a guide.
Before connecting the power cord of your monitor, make sure that the video cable has been correctly connected. Make sure your computer’s and monitor's power is OFF. We recommend that you switch on the monitor first, before switching on the computer!
MONITOR CONTROLS (SEE THE ILLUSTRATIONS AT THE START OF THIS GUIDE)
You must perform auto setup before making any adjustment.
The Power button (A) switches your monitor on and off. We recommend you switch the monitor on before switching the computer on. Press the MENU Button (B) to access the OSD menu. For your information the current resolution and fre- quency are displayed at the top of the menu box. Press the DOWN Button (C) or the UP Button (D) to choose the item you want to adjust. Use the MENU Button (B) to choose the modification. Then the DOWN and UP buttons allow you to decrease or increase the value of the selected control. Press the MENU Button to confirm a selection. The Contrast and Brightness are directly accessible from the DOWN and UP buttons.
CT500p/CT700p: Use the AUTO Button (E) to automatically adjust the monitor display to its optimum setting.
CC700p: Use the EXIT Button (E) to exit the OSD menu.
DRIVERS
Under normal circumstances your computer will be equipped with the necessary drivers for the Packard Bell monitor. However if your computer does not already have these drivers you may download them from the support section of the Packard Bell website at www.packardbell.com
FURTHER INFORMATION
For further information a fully comprehensive guide is available on the CD which may have been supplied with your moni- tor. Insert the CD into an available disk drive and select your monitor from the list that appears on the opening screen. If it does not start automatically go to Start > My Computer > Monitor Guide > welcome.htm
1
