Setting the functions
Setting the speed at which to move to the position set by the preset memory
The speed at which to move to the position where the remote camera has been set to be in the preset memory when the preset operation is conducted can be set.
From the [SETUP] menu, select [PRESET] and display [DIAG SPEED]. Then set the speed.
The higher the setting, the faster the operating speed.
1.DIAG SPEED ▼
1
Returning the remote cameras to their home position
The remote cameras connected can be returned to their home position.
From the [SETUP] menu, select [PRESET] and display [HOME POSITION]. Then press the F2 dial.
3.HOME POSITION▲ SET
Setting the operations to be performed when a preset operation is executed
The operations which the remote camera is to performed when the preset operation is conducted can be set.
From the [SETUP] menu, select [PRESET] and display [SCOPE]. Then set the operations to be performed.
2.SCOPE
MODE A
The operations that the camera performs when a preset operation is executed differ depending on the mode selected.
Mode | Operations performed |
|
|
MODE A | Pan, tilt, zoom, focus, iris, gain, white balance |
|
|
MODE B | Pan, tilt, zoom, focus, iris |
|
|
MODE C | Pan, tilt, zoom |
|
|
Note
This function takes effect when the unit is connected to the
Adjusting the panning, tilting, zooming and focusing speed
The speed is adjusted uniformly for the panning, tilting, zooming and focusing together.
When the PTZ/FOCUS SPEED dial is turned clockwise, the speed is increased; conversely, when it is turned counterclockwise, it is reduced.
| 1 | 2 | 3 | 4 | 5 |
IRIS | AUTO | CAMERA STATUS / SELECTION | PT ACTIVE | ||
|
|
|
AUTO
ZOOM
LOW HI
WIDE | FOCUS/PUSH OTAF | PTZ/FOCUS SPEED PAN/TILT |
From the [SETUP] menu, select [OPERATE] and display [SPEED TARGET]. If P/T is selected, the speed adjustment is confined to panning and tilting only.
In this case, the zooming and focusing speed is fixed to the speed which was set immediately before P/T was selected.
21