Setup Software
Auto IP setting
When IP addresses are to be changed
1 Click [RENEW].
New IP addresses are set in the target remote cameras and switcher.
When [CANCEL] is clicked, the original settings are restored.
2 Check that the IP addresses of the remote cameras and switcher are displayed correctly, and click [SET].
The IP addresses which have been set now take effect.
When IP addresses are not going to be changed
1 Click [KEEP].
The IP addresses of the target remote cameras and switcher are displayed.
When [CANCEL] is clicked, the original settings are restored.
2 Check that the IP addresses of the remote cameras and switcher are displayed correctly, and click [SET].
The displayed IP addresses now take effect.
Changing the IP addresses
The IP addresses of the remote cameras and switcher can be changed.
1 Directly input the IP address of the device concerned into the [IP Address] box.
2 Click [SET].
The changed IP address now takes effect.
Changing the camera numbers
The camera numbers set for the remote cameras can be changed.
1 Change the camera number for the remote camera concerned in the [CAMERA Select] box.
2 Click [SET].
The changed camera number now takes effect.
Registering the camera numbers in the switcher’s input connectors
Set the camera numbers to be registered for the input connectors (SDI IN 1 to SDI IN 4, DVI IN) of the switcher.
1 Select the camera numbers to be registered in the [SW Input] box.
SW Input display | Input connector of switcher |
|
|
Input1 |
|
|
|
Input2 |
|
|
|
Input3 | SDI IN 1 to SDI IN 4, DVI IN |
|
|
Input4 |
|
|
|
Input5 |
|
|
|
2 Click [SET].
The registration of the camera numbers into the input connectors of the switcher now takes effect.
Initializing the IP addresses
The set IP addresses are initialized when [ALL CLEAR] is clicked.
Acquiring information
When [REFRESH] is clicked, the latest information of the remote cameras and switcher is acquired, and displayed in the “Setting” tab.
40