![](/images/new-backgrounds/1316647/31664745x1.webp)
Settings (continued)
English
43
(AUDIO continued)
SP SETUP (Speaker set up)
Setting the absence/presence and size of each speaker
FRONT | (Front speaker setting) |
LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)
SMALL : for small speakers, or when bass playback is not possible
| default: | LARGE |
|
| |
CENTER | (Center speaker setting) |
LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)
SMALL : for small speakers, or when bass playback is not possible
NONE : when not using a center speaker
default: NONE
*A center speaker (option,
SURROUND (Surround speaker setting)
LARGE | : for large speakers, when bass playback is | |||
| possible (at least 100 Hz or lower) | |||
| ||||
| : for small speakers, or when bass playback is | |||
SMALL | ||||
| not possible | |||
NONE | : when not using a surround speaker | |||
|
| default: |
|
|
|
| LARGE | ||
|
|
|
|
|
SUB - W | (Subwoofer speaker setting) | |||
| : when using a subwoofer | |||
YES | ||||
| : when not using a subwoofer | |||
NO | ||||
|
| default: |
| |
|
| NO |
*A subwoofer (option,
Note:
¡While the private mode is active, only FRONT can be
adjusted.
SP LEVEL (Speaker level)
Adjusting the output balance of each speaker
FRONT L |
| (Left front speaker output bal- | |
| ance) | ||
] : down, | [ : up |
| |
CENTER |
| (Center speaker output balance) | |
] : down, | [ : up |
| |
|
|
| (Right front speaker output bal- |
FRONT R |
| ||
| ance) | ||
] : down, | [ : up |
| |
|
|
| (Right surround speaker output |
R¡SURROUND |
| ||
| balance) | ||
] : down, | [ : up |
| |
|
|
| (Left surround speaker output |
L¡SURROUND |
| ||
| balance) | ||
] : down, | [ : up |
| |
|
|
| (Subwoofer speaker output bal- |
SUB - W |
| ||
| ance) | ||
] : down, | [ : up |
|
Setting range:
A test signal (a continuous tone) is output from each speaker for approximately 2 seconds.
Adjust the output balance so that the tone appears to have the same volume from each speaker.
Adjusting the output balance:
Adjust the volume of all of the other speakers to the volume level of the speaker from which the test signal appears to be the quietest.
¡If the speaker setting is NONE (none) or NO (no) for a speaker, the test signal is not output and that speaker cannot be selected.
¡Turn rotary volume controller or press [}] or [{] (VOL) to adjust the volume of the test signal.
Note:
¡While the private mode is active, only
FRONT L and
FRONT R can be
adjusted.
SP DELAY (Speaker delay)
Adjusting the timing with which the audio from each speak- er reaches the listener’s position
(Center speaker delay time set-
CENTER ting)
] : down, [ : up
Setting range: 0 ms to 5 ms (1 ms steps) 1 ms = 0.001 seconds default: 0 ms
(Surround speaker delay time
SURROUND setting)
] : down, [ : up
Setting range: 0 ms to 15 ms (1 ms steps)
1 ms = 0.001 seconds default: 0 ms
¡Make this adjustment while listening to sound.
¡If the speaker setting is NONE (none) for a speaker, that
speaker cannot be selected.
¡When “PRO LOGIC” is displayed, 15 ms are automatically added to the delay time setting for the surround speakers.
MODE LEVEL
Setting the VTR/AUX input level
Make this setting if it is not possible to adjust the volume through the connected device (on the output side).
VTR LEVEL | (Setting for VTR) | ||
| : sets the level low/sound volume increases | ||
LOW | |||
| : sets the level high/sound volume decreases | ||
HIGH | |||
|
| default: |
|
|
| HIGH | |
|
|
|
|
AUX LEVEL | (Setting for AUX) | ||
| : sets the level low/sound volume increases | ||
LOW | |||
| : sets the level high/sound volume decreases | ||
HIGH |
Note:
¡If the input level from VTR/AUX is too high, the audio will not be output normally.
¡After setting the input level
The volume can be adjusted by pressing [}] or [{] (VOL) on the remote control or turning rotary volume controller on the unit.
LPF/HPF (Low Pass Filter/High Pass Filter) Cut off frequency
LPF CUT OFF |
| ||||||||||||
| : down, |
| : up |
|
|
|
|
|
|
|
|
| |
] | [ |
|
|
|
|
|
|
|
|
| |||
|
| Setting range: |
| - |
|
| (in 5 | Hz step) | |||||
|
| 60 Hz | 160 | Hz | |||||||||
|
|
|
|
|
|
|
|
|
| default: |
|
|
|
|
|
|
|
|
|
|
|
|
| 100 Hz | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
HPF CUT OFF |
| (High Pass Filter) |
|
|
|
|
| ||||||
| : down, |
| : up |
|
|
|
|
|
|
|
|
| |
] | [ |
|
|
|
|
|
|
|
|
| |||
| Setting range: OFF , |
| - |
|
| (in 5 | Hz step) | ||||||
90 Hz | 225 | Hz | |||||||||||
|
|
|
|
|
|
|
|
|
| default: |
| ||
|
|
|
|
|
|
|
|
| OFF |
Note:
¡This setting is not available if CS Auto (SRS setting) is set to ON (on).
¡HPF CUT OFF (High pass filter) is enabled only on the front speakers (R/L) and rear speakers (L/R).
English
44
default: HIGH
|
| : Previous menu | : Quit | : Select/adjust |
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| [MENU] : Previous menu | [MODE] : Quit | []] [[] [}] [{] : Select/adjust | [ENTER] : Determine | ||
| |||||||
| |||||||
|
|
|
|
|
|
|
|
|
| : Previous menu | : Quit | : Select/adjust |
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| [MENU] : Previous menu | [MODE] : Quit | []] [[] [}] [{] : Select/adjust | [ENTER] : Determine | ||
| |||||||
| |||||||
|
|
|
|
|
|
|
|
44
45