Base Unit Settings

3

4

Change the network setting on your computer.

L If DHCP is enabled for obtaining IP address on your computer, you need to obtain IP address again.

L If Static IP address is entered on your computer, you need to change IP address and subnet mask on your computer manually. See “Setting the static IP address on your computer” (page 207).

L Other operations may be possible for recovering the Network setting on your computer.

Click the IP address shown on the restarting page. L The Top Menu is displayed.

L WAN Indicator flashes as a short blinking in Amber and a long flash in Green in turn. This state indicates that the connection to the WAN side of the base unit has been recovered for the Internet connection. During this state, Port Forwarding, DMZ, Packet Filtering and Static Routing functions are disabled.

Note:

L In step 2, Configuration Error message is displayed if network still overlaps or your data entry is not correct. You need to try to enter the IP address, Subnet mask and Starting IP address (DHCP Server) again. See also the Help on the LAN (temporary) heading for data entry.

L The IP address, Subnet mask and Starting IP address (DHCP Server) entered in the Temporary setting are effective while the base unit is turned on, and will be cleared away from the unit when the base unit is turned off.

L If you want to change the LAN side settings permanently, click [Top Page] button on the right top of the Temporary LAN Side Network Setting page and change the LAN side settings from [Advanced Setup].

Helpline Tel. No.: U.K. 0844 844 3898

201

Page 201
Image 201
Panasonic KW-WP1050E operating instructions 201