Panasonic KW-WP1050E operating instructions Base unit Indicators Problem Cause/Solution

Useful Information

Base unit Indicators:

Problem	Cause/Solution
The WAN Indicator is	L The base unit hardware may be defective.
blinking in red.	L Unplug the base unit’s AC adaptor. Reconnect the
	adaptor and try again.
	L If this doesn’t resolve the problem, visit
	http://www.panasonic.co.uk
	Then enter model no. KX-WP1050.
The WAN Indicator is	L The base unit firmware may be defective and requires
blinking in amber.	an update firmware (page 202).
The WAN Indicator is	L An Internet connection has not yet to be established.
amber.	L Check the Internet connection settings.
	L Check that you are required to register MAC address
	(page 153).
	L When you change the Internet connection device from
	your existing router to the base unit, it may take time to
	connect.
The WAN Indicator	L The networks on the WAN side and the LAN side
alternately flashes in	overlap. Change the LAN side network settings
amber and green in turn.	(“Temporary LAN Side Network Setting when networks
	on the WAN side and the LAN side overlap” on page
	199).
The WAN Indicator	L LAN side network setting is changed temporarily
flashes as a short blinking	(“Temporary LAN Side Network Setting when networks
in amber and a long flash	on the WAN side and the LAN side overlap” on page
in green in turn.	199).
The WAN Indicator is off.	In the hotel room:
	L Check that the base unit and the Ethernet port (RJ45
	socket) in the hotel room are connected properly.
	L Check that the power of the base unit is turned on.
	At home:
	L Check that the base unit and your device (modem,
	existing router or modem with a build-in router) are
	connected properly.
	L Check that the power of the base unit and your device
	are turned on.

222 Helpline Tel. No.: U.K. 0844 844 3898