Base Unit Settings

Note:

L In step 5, enter the handset’s IP address into the “Do not use proxy server for addresses beginning with:” data field when you update the firmware of the handset.

Setting UPnP to display the shortcut

To display the KX-WPA102 shortcut in the My Network Places folder or the Network folder, Windows components should be added. Enable UPnP (Universal Plug and Play) following the steps below.

L Windows XP

1 Click [Start], then click [Control Panel].

2 Click [Add or Remove Programs], then click [Add/Remove Windows Components].

3 Select [Networking Services], then click [Details…].

4 Check [Universal Plug and Play], then click [OK].

5 Click [Next>].

Note:

L If you are using Windows XP Service Pack 2, check [Internet Gateway Device Discovery and Control Client] and [UPnP User Interface] in step 4.

L Windows Vista

1 Click [Start], then click [Control Panel].

2 Click [Network and Sharing Center], then click [network discovery]. 3 Select [Turn on network discovery].

4 Click [Apply].

Using your computer on a wireless LAN

The 15 character device-specific network name (SSID) and 13 alphanumeric character 128 bit encryption network key (WEP) are set as factory defaults. These factory default setting values are shown on the included Wireless LAN sticker. If you use your computer on a wireless LAN, use the values on the sticker to set the wireless LAN configuration on your computer. To set your computer to be used on a wireless LAN, see the manual for the computer you use.

212

Helpline Tel. No.: U.K. 0844 844 3898

Page 212
Image 212
Panasonic KW-WP1050E operating instructions Setting UPnP to display the shortcut, Using your computer on a wireless LAN