7. Programmable Features
Code #41: Changing the fax activation code
FAX ACTIVATION
=ON[±]
If you wish to use an extension telephone to receive faxes, activate this feature and program the activation code.
1.Press {MENU}.
2.Press {#}, then {4}{1}.
3.Press {A} or {B} repeatedly to select “ON”.
4.Press {SET}.
5.Enter your code from 2 to 4 digits, using
{*} and {#}.
L The default code is “;;;9”. L Do not enter “0000”.
6.Press {SET}.
7.Press {MENU}.
Code #44: Setting the memory reception alert
RECEIVE ALERT
=ON[±]
To alert you with a beeping sound when a received fax document is stored into memory due to some existing problem.
The slow beeps will continue until you clear the printing problem and make sure the unit is supplied with enough paper to print the stored document.
“ON” (default): You will be alerted to a reception problem by a beeping sound.
“OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
=ON[±]
To receive a fax automatically when you answer a call and hear a fax calling tone (slow beep). “ON” (default): You do not have to press {FAX START} for fax reception.
“OFF”: You have to press {FAX START} for fax reception.
Code #49: Setting the auto disconnection
AUTO DISCONNECT
=ON[±]
To answer a call with an extension telephone in TEL/FAX mode (page 33), activate this feature and program the code.
1.Press {MENU}.
2.Press {#}, then {4}{9}.
3.Press {A} or {B} repeatedly to select “ON”.
4.Press {SET}.
5.Enter your code
L The default code is “;0”.
6.Press {SET}.
7.Press {MENU}.
Code #58: Setting the scan contrast
SCAN CONTRAST
=NORMAL [±]
To send or copy a document with faint or dark writing, set this feature before starting transmission or copying.
“NORMAL” (default): Used for normal writing.
“LIGHT”: Used for faint writing.
“DARKER”: Used for dark writing.
Code #68: Setting the Error Correction Mode (ECM)
ECM SELECTION
=ON[±]
This feature is available when the transmitting/receiving fax machines are ECM compatible.
“ON” (default): To send a fax even if there is static interference on the telephone line. “OFF”: Deactivates this feature.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON[±]
If you often have trouble when sending faxes, this feature allows you to hear connecting tones: fax tone, ring back tone and busy tone. You can use these tones to confirm the status of the other party’s machine.
“ON” (default): You will hear connecting tones.
“OFF”: Deactivates this feature.
LIf the ring back tone continues, the other party’s machine may not be a fax machine or may have run out of paper. Check with the other party.
LThe connecting tone volume cannot be adjusted.
Code #77: Changing the receiving mode in the auto answer setting
AUTO | ANSWER | [±] |
=FAX | ONLY |
“FAX ONLY” (default): Fax only mode (page 33)
“TEL/FAX”: Telephone/Fax mode (page 33)
42
