8. Help

 

 

 

 

8.3.2 General

 

 

 

Problem

Cause & Solution

The unit displays “PAPER

L You forced the recording paper into the paper tray too strongly. Remove all

JAMMED” even though paper

of the installed paper, and re-install it gently.

is installed.

 

The unit displays “CHECK

L The paper is inserted halfway. Insert it correctly (page 44) and press {SET}

PAPER” even though paper is

to clear the message.

inserted.

 

The other party complains

L FAX ONLY mode is set. Tell the other party the number is only used for

they only hear a fax tone and

faxes.

cannot talk.

L Change the receiving mode to TEL mode (page 24).

 

L If you use a Distinctive Ring service, make sure you have set the same ring

 

pattern assigned by the telephone company (page 27).

 

 

{REDIAL} or {PAUSE} does

L If this button is pressed during dialing, a pause will be inserted. If pressed

not function properly.

immediately after a dial tone is obtained, the last number dialed will be

 

redialed.

 

 

The receiving mode does not

L Distinctive Ring is set (feature #31 on page 27).

function properly.

 

 

 

The ink film runs out quickly.

L Even if there are only a few sentences, every page that comes out of the

 

machine is considered a full page.

 

L Turn OFF the following features:

 

– confirmation report: feature #04 on page 31.

 

– journal report: feature #22 on page 32.

 

– Caller ID list: feature #26 on page 32.

 

 

The unit beeps.

L The memory reception alert of feature #44 is ON (page 34), and the unit has

 

a document in memory. Press {STOP} to stop the beeps, then see the

 

displayed message instructions to solve the problem.

 

 

Whenever I try to retrieve my

L You are probably entering {*}{#}{9}. This is the default setting for the fax

voice mail messages, I am

activation code. If you use a voice mail service, turn the fax activation

interrupted by the fax tone.

feature OFF or reprogram the activation code (feature #41 on page 34).

 

 

The unit does not display the

L You need to subscribe to a Caller ID service.

caller’s name and/or

L Other telephone equipment may be interfering with your phone. Disconnect

telephone number.

it and try again.

 

L Other electrical appliances connected to the same outlet may be interfering

 

with the Caller ID information.

 

L Telephone line noise may be affecting the Caller ID information.

 

L The caller requested not to send his/her information (page 17).

 

 

The display exits the Caller ID

L Do not pause for over 3 minutes while viewing.

List while viewing caller

 

information.

 

 

 

For assistance, please visit http://www.panasonic.com/consumersupport

39

Page 39
Image 39
Panasonic KX-FP205 operating instructions General