Panasonic KX-FP85AL, KX-FP81AL manual Other remote operations

Remote Operation (KX-FP85 only)

Other remote operations

■Erasing a specific message

Press 4 while listening to the message you want to erase.

Voice guide example:

The message has been erased.

●A long beep will also sound. The unit will then play back the next message.

■Erasing all the messages

Press 5 to erase all the messages.

All messages have been erased.

●A long beep will also sound.

■Monitoring the room (KX-FP85AL only)

Press 6 to monitor the sound for about 30 seconds in the room where the unit is installed.

●After 30 seconds, a beep sounds. To continue monitoring, press 6 again within 10 seconds.

■Recording a marker message

You can leave an additional message.

1.Wait for the voice guide.

All messages have been played.

2.Wait about 10 seconds.

Please leave your name and message after the beep.

3.Leave a message after the beep.

■Turning the message transfer on or off

You must pre-program a transfer telephone number beforehand (feature #60 on page 72).

Press 8 1 to turn ON the message transfer.

Message transfer is set. Transfer phone number is 123456789.

Press 8 2 to turn OFF the message transfer.

Message transfer is off.

●If a transfer telephone number is not programmed, you cannot turn this feature ON.

Transfer phone number is not set.

■Turning the pager call on or off

You must program a pager number beforehand (feature #70 on page 51).

Press 8 3 to turn ON the pager call.

Pager call is set.

Pager number is 098765432.

Press 8 4 to turn OFF the pager call.

Pager call is off.

●If a pager number is not programmed, you cannot turn this feature ON.

Pager number is not set.

■Re-recording a greeting message

You can change the contents of the TAD/FAX greeting message.

1.Press 7 to start recording.

●A long beep will sound.

2.Speak clearly up to 16 seconds.

●If you pause for over 2 seconds, 6 beeps will sound and the recording will stop. Repeat from step 1 within 10 seconds.

3.When finished recording, press 9 .

●The new greeting message will be played.

■Skipping the greeting message

Press 0 during the greeting message playback. ● The unit will skip the rest of the greeting

message.

■Changing the receive mode

Press 8 0 to change the receive mode from TAD/FAX to TEL.

●You cannot return to the TAD/FAX mode in the same call. To return to the TAD/FAX mode, see page 48.

63