OperatingInstructions
94
3.5.15 Reset to Factory Default
Reset to Factory Default window initializesall the parameters including the ID,
Password,IP address and Subnet Mask except Date and Time setting to the
factory default. Reconfirmthe settings before doing the Reset to Factory Default
operation.
1. Click [Reset to Factory Default]on Setu p Page.
2. Click [Execute].
• Indicatorchanges such as Orange blinking twice –> Tur ning o ff
about 15 seconds. Initializingtakes about one minute.
•Click[Cancel]to quit. The window returns to Setup Page.
Notes
• Donot tur n off the powerduring the Reset to Factory Default. It may
interrupt the Network Camera operation.
• IPaddress and Subnet Mask should be set again after Resetting to
Factory Default.
• CLEARSETTING button can also reset Network Camera to the
Factory Default. Refer to page 112.
• Internalclock will not be reset, however, time mode will return to AM/
PM mode and Auto adjustment wil l be disabled.
• IfReset to Factory Default is used, all usersettings will be lost, and you
will have to reconfigurethe entire Network Camera.