Making and Answering Calls
Making Calls
1.Confirm that the desired line ("IP" or "TEL") is selected.
•You can change the selected line by pressing the center function button ([F2]).
The IP line is selected. | The TEL line is selected. |
[F2][F2]
•If you cannot select the desired line, change the "Line Selection" setting (see page 30).
2.Press [
].
3.For TEL calls: Enter the phone number.
For IP calls with
For IP calls with peer to peer connection: Enter the IP address, then press [#] or [ENTER].
•IP addresses can be entered using the keypad. 
] is used to enter a period. For example, to enter "192.168.0.1", press [192
168
0
1].
•To temporarily use tone dialing when the line mode is set to pulse mode, press [
].
•After a call starts, the approximate length of the call is shown on the display.
4.To end the call, press [
].
Note
•To make a call using the phonebook, see page 32.
•To make a call with a Portable Station (PS) or computer connected to the unit, see page 41 or page 42.
•During the first 30 seconds of a TEL call, the unit adjusts itself for optimal sound quality. Speak in turns with the other party at the beginning of a conversation. (The time required varies depending on the condition of the telephone line and the audio characteristics of the room.) During this time, sound may cut out or fade in and out. This is normal.
•If the unit is not connected to an IP network,
IP is not displayed and the IP line cannot be selected.
•The call length shown on the display is an approximation and may differ from the actual length of the call. Call charges accumulate after the called party answers.
Adjusting the Speaker Volume
While on a call, press [
] or [
] repeatedly to adjust the speaker volume. There are 8 levels of volume.
Quieter | Louder |
•If the other party has difficulty hearing you, press [
] to decrease the speaker volume. Your voice heard by the other party will become louder.
Making a Call After Entering the Phone Number or IP Address
1.Confirm that the desired line ("IP" or "TEL") is selected.
•You can change the selected line by pressing the center function button ([F2]).
The IP line is selected. | The TEL line is selected. |
[F2][F2]
•If you cannot select the desired line, change the "Line Selection" setting (see page 30).
2.For TEL calls: Enter the phone number.
For IP calls with
For IP calls with peer to peer connection: Enter the IP address.
•If you make a mistake, press [
], then enter the correct phone number or IP address. To
erase all numbers, press and hold [
].
•If a pause is required when making a call on the TEL line, press [REDIAL/PAUSE] between digits as necessary.
3.Press [
] or 
.
4.To end the call, press [
].
Document Version 2008/10 | Operating Instructions |
31
