Panasonic KX-NT700 Changing Settings, Restarting the Unit, Using the Front Panel

Programming the Unit

Changing and Confirming Settings

Settings can be programmed and confirmed from the front panel. To use Conferencing Phone Manager (found on the included CD-ROM) to program the unit from a computer, see page 58.

Changing Settings

Using the Front Panel

1.Press [MENU].

2.Press [] or [] to select the desired programming category, then press SELECT .

3.Press [] or [] to select the desired parameter, then press SELECT .

4.Adjust the settings as desired.

•To cancel without changing any settings, press [MENU].

5.Press SAVE .

6.Press [MENU].

Note

•When programming the unit from the front panel, the current setting is indicated on the display by "ü".

•To return to the previous screen, press [BACK].

•If you do not press any buttons for 1 minute, the unit will return to standby mode.

•The following parameters cannot be programmed, and are therefore not displayed, when the unit is in use.

–Operation Mode

–Language

–Date & Time

–Time Format

–Ringer Volume

–Ringtone

–IP Network Settings (all parameters)

–Protocol Settings (all parameters)

–VoIP Settings (all parameters)

–QoS Settings (all parameters) Additionally, the following parameters cannot be programmed, and are therefore not displayed, when the TEL, PS, or PC line is in use.

–Line Selection

–TEL Settings (all parameters)

Using Conferencing Phone Manager

To use Conferencing Phone Manager (found on the included CD-ROM) to program the unit from a computer, see page 58.

Restarting the Unit

After changing the following parameters, the unit must be restarted in order for the new settings to take effect. (Data is not erased when the unit is restarted.)

–Operation Mode (page 46)

–IP Address Mode (page 49)

–IP Address (page 50)

–Subnet Mask (page 50)

–Default Gateway (page 50)

–SIP Ext. No. (page 50)

–SIP Password (page 51)

–SIP User Domain Name (page 51)

–SIP Proxy Server IP Address (page 51)

–SIP Registrar IP Address (page 51)

–Hold Method (page 51)

–SIP Signaling Port Number (page 52)

–VLAN ID (page 53)

–VLAN Priority (page 53)

–SIP ToS Field (page 53)

–RTP ToS Field (page 53)

1.Press [MENU].

2.Select "System Options", then press SELECT .

3.Select "Reboot", then press SELECT .

4.Select "Yes", then press SELECT .

Note

•To use Conferencing Phone Manager to restart the unit, see page 58.

•You can also restart the unit by turning it off and on again:

–When using the AC adaptor: Disconnect the AC adaptor from the AC outlet, then connect it again.

–When using PoE: Disconnect the LAN cable from the unit, then connect it again.

Document Version 2008/10 Operating Instructions

43