Setting the Date & Time
Set the unit's date and time setting before using the unit.
The date and time are shown on the display in standby
mode, and are displayed when playing conversations
that were recorded to an SD memory card.
1. Press [MENU].
2. Select "Basic Settings", then press
SELECT
.
3. Select "Date & Time", then press
SELECT
.
4. Using the keypad, enter 2 digits each for the year,
month, day of the month, hour (24-hour format), and
minute.
Example: To enter "Jan. 23, 2008, 7:45 PM", press
[0801231945].
•If you make a mistake, press to move
the cursor as needed, then enter the correct
number.
5. Press
SAVE
.
6. Press [MENU].
Note
•You can select 12-hour or 24-hour time display
(see page 47).
•The date format varies by the selection made
for the "Language" setting. See page 46 for
details.
TEL Line Settings

Selecting the Available Lines

To use the TEL line, the "Line Selection" setting
must be set to "IP + TEL". (This is the default setting.)
1. Press [MENU].
2. Press
LINE
.
3. Select "IP + TEL".
•When "Line Selection" is set to "IP +
PC" or "IP + PS", TEL calls cannot be made or
received.
4. Press
SAVE
.
5. Press [MENU].

Setting the Dial Mode

Set the dial mode to "Pulse" if the TEL line does not
support tone dialing.
1. Press [MENU].
2. Select "TEL Settings", then press
SELECT
.
3. Select "Dial Mode", then press
SELECT
.
4. Select "Pulse" or "Tone".
5. Press
SAVE
.
6. Press [MENU].
Document Version 2008/10 Operating Instructions 23
Preparation