Introduction
Do not touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
If using an AC adaptor, use only the included AC adaptor (PQLV206).
The AC adaptor should be connected to a vertically oriented or
Only connect the unit to the type of electric power specified on the label affixed to the unit. Confirm the type of electric power supplied to the installation site if necessary.
Use caution when installing or modifying telephone lines.
Placement
Do not expose the unit to contact with liquids (rain, water, moisture, oil, etc.) or excessive smoke or dust. Do not subject the unit to excessive shock.
Do not allow anything to rest on the AC adaptor cord or LAN cable. Do not locate this unit where the AC adaptor cord or LAN cable may be stepped on or tripped on.
Place this unit on a flat surface. Serious damage and/or injury may result if the unit falls.
Allow 10 cm (3 15/16 in) clearance around the unit for proper ventilation.
CAUTION
Do not place heavy objects on top of this unit.
When the unit receives power from the AC adaptor, the AC adaptor is the main disconnect device. Ensure that the AC outlet is installed near the unit and is easily accessible, so that the unit can be disconnected from the AC outlet if necessary.
Disconnect the AC adaptor cord and all cables from the unit before cleaning. Clean the unit with a soft, dry cloth. Do not use liquid, aerosol cleaners, abrasive powders, or chemical agents to clean the unit.
The SD memory card poses a choking hazard. Keep the SD memory card out of reach of children.
When left unused for a long period of time, disconnect the unit from the AC outlet. When the unit receives power from a PoE power supply, disconnect the LAN cable.
Notice
•Read and follow all instructions, warnings, cautions, etc. including those marked on the unit.
•Before connecting the unit, confirm that the unit supports the intended operating environment.
•If the unit does not operate properly, disconnect the AC adaptor cord and LAN cable, then connect again.
•The unit may not operate in the event of a power failure. Ensure that a separate telephone, not dependent on local power, is available for use in case of emergency.
•Do not move the unit while it is in use.
•To prevent malfunction, deformity, overheating, rust, and discoloration, do not install or place equipment in the following types of locations:
–Locations exposed to direct sunlight.
–Locations where the temperature is less than 0 °C (32 °F) or greater than 40 °C (104 °F).
–Locations where there is high humidity.
–Locations where air ventilation is poor.
–Locations that may be exposed to sulphurous gas, such as near hot springs.
–Near devices that emit heat, such as heaters.
–Near devices that emit electromagnetic noise, such as radios or televisions.
–Near devices that emit
•Do not place credit cards, ATM cards, or other magnetic cards near the unit. The magnets in the unit’s speaker and microphones may damage magnetic cards.
•If an error message is shown on the unit’s display, consult the network administrator.
•Satisfactory operation, interoperability, and compatibility cannot be guaranteed with all equipment connected to the unit, nor with all services provided by telecommunications providers over networks connected to the unit.
Document Version 2008/10 | Operating Instructions |
9
