Redialing
The last 10 calls made are stored in the redial list, in
order of newest to oldest call.
1. Press [REDIAL/PAUSE].
•The last call made is displayed.
2. Press [ ] or [ ] repeatedly to scroll through the
list.
•To erase the displayed item, press
ERASE
.
•To exit the redial list, press [MENU].
3. When the desired entry is displayed, press [] or
.
Note
•The line that was used to make each call in the
redial list ("IP" or "TEL") is shown in the
lower-right corner of the display. This line will be
used when the call is redialed.
Example:
The TEL line will
be used when you
redial this
number.
•If the "Line Selection" setting is not set
to "IP + TEL" (see page 30), TEL line calls
cannot be redialed.
•If the dialed number contains too many digits
(more than 32 digits for IP calls with IP-PBX
connection, more than 128 digits for TEL calls),
it cannot be redialed correctly.
Entering Dialing Pauses
A pause is sometimes required when making calls on
the TEL line using a PBX or a long distance service. For
example, if you must dial "9" before dialing an outside
phone number, you probably wait (pause) after
dialing "9" until you hear a dial tone.
By pressing the [REDIAL/PAUSE] button when dialing,
the unit will store the dialing pause along with the phone
number in the redial list. If you make a call from the
redial list later, the unit will dial the number wait for the
pre-programmed number of seconds (default: 3 s; see
page 49) for each dialing pause you entered.
Example:
1. Press [9] (to access an outside line of a PBX).
2. Press [REDIAL/PAUSE].
•Press [REDIAL/PAUSE] repeatedly to create
longer pauses. An additional pause is inserted
each time [REDIAL/PAUSE] is pressed.
3. Dial the phone number.
4. Press [ ] or .
Making a Call from the Phonebook
See page 36 to add entries to the phonebook.
1. Press .
2. Press [ ] or [ ] repeatedly to scroll through the
phonebook entries.
•Entries are displayed in the following order
when [ ] is pressed.
Symbols®Numbers®Letters
•Press the dial key corresponding to the desired
character, then press [] or [ ] to scroll if
necessary.
•To exit the phonebook, press [MENU].
3. When the desired entry is displayed, press [] or
.
Note
•The line that was selected when the entry was
stored in the phonebook ("IP" or "TEL") is
shown in the lower-right corner of the display.
This line will be used when the entry is called.
Example:
The TEL line will
be used when you
call this number.
•If the "Line Selection" setting is not set
to "IP + TEL" (see page 30), TEL line numbers
cannot be called.
32 Operating Instructions Document Version 2008/10
Making and Answering Calls