Panasonic KX-UTG200, KX-UTG300 1.1 Setup

1.1 Setup

Many of the settings for this unit have been configured before the unit ships.

Where possible, these settings are configured with the optimum or most common values for the setting. For

example, the port number of the SIP (Session Initiation Protocol) server is set to "5060".

However, many of the settings, such as the address of the SIP server or the phone number, have not been

pre-configured, and they must be modified depending on the usage environment. If the port number of the SIP

server is not "5060", the value of this setting must be changed.

This unit thus will not function properly using only the factory default settings. The settings for each feature

must be configured according to the environment in which the unit is used.

This section describes the basic network settings that you must configure before you can use the unit on your

network.

You must configure the following network settings:

•TCP/IP settings (DHCP [Dynamic Host Configuration Protocol] or static IP address assignment)

•DNS server settings

The unit supports both IPv4 and IPv6.

A unique IP address must be assigned to the unit so that it can communicate on the network. How you assign

an IP address depends on your network environment. This unit supports the following 2 methods for assigning

an IP address:

You can configure the unit to automatically obtain its IP address when it starts up from a DHCP server running

on your network. With this method, the system can efficiently manage a limited number of IP addresses. Note

that the IP address assigned to the unit may vary every time the unit is started up.

For details about the DHCP server, consult your network administrator.

If IP addresses for network devices are specified individually by your network administrator, you will need to

manually configure settings such as the IP address, subnet mask, default gateway, and DNS servers.

For details about the required network settings, consult your network administrator.

You can configure the unit to use 2 DNS servers: a primary DNS server and a secondary DNS server. If you

set both DNS servers, the primary DNS server receives priority over the secondary DNS server. If the primary

DNS server returns no reply, the secondary DNS server will be used.

For details about configuring the DNS server settings using the unit, or using the Web user interface, see

Configuring the Network Settings of the Unit in this section.

24 Administrator Guide Document Version 2014-05

1.1.2 Basic Network Setup