3.1 Phone User Interface Programming
This section provides information about the features that can be configured directly from the unit, but that are
not mentioned in the Operating Instructions.
To enter direct commands, use the dial keys and soft buttons on the unit.
For details about the other available features, settings and key operations on the phone user interface, refer
to the Operating Instructions on the Panasonic Web site (® see Introduction).

3.1.1 Phone User Interface Feature List and Direct Commands

The following table shows additional features programmable with direct commands. These commands are
hidden from end users.
Direct
Command Feature Ref.
[#][1][3][6] Resetting the unit Page 33
[#][5][3][4] Embedded web Page 28
[#][5][9][0] Port Mirroring Page 54
[#][6][1][1] Disable the touch screen Page 54

3.1.2 Port Mirroring Settings

Port mirroring is used for network monitoring and debugging purposes.
You can enable port mirroring by performing the procedure below from the unit.
To enable port mirroring
1. On the Home screen, select .
2. Press [#][5][9][0].
3. Select
Yes
.

3.1.3 Disabling the Touch Screen

Touch for the screen can be disabled. This is convenient when cleaning the screen.
You can disable touch for the screen by performing the procedure below from the unit.
To disable touch for the screen
1. On the Home screen, select .
2. Press [#][6][1][1].
3. Select
Yes
.
•Press [#][6][1][1] to enable the screen again.
54 Administrator Guide Document Version 2014-05
3.1.3 Disabling the Touch Screen