zzError details

Error message

Remedy

 

zzSet no more than eight

 

projectors in one group.

 

zzUse a computer and

[Exceed maximum

the dedicated “Multi

number of projectors.]

Projector Monitoring &

 

Control Software”*1 to

 

connect nine or more

 

projectors.

 

zzSet the on-screen menu

 

[NETWORK CONTROL]

 

[COMMAND CONTROL]

[Please check the

to [ON] for the projector

in error.

COMMAND CONTROL

zzSet the [NETWORK

setting.]

CONTROL] [COMMAND

 

 

PORT] of all projectors

 

to be connected to the

 

same value.

 

zzSet the same character

[Please check the

string to the [User

USER NAME and

name] and [Password]

PASSWORD in the

that has Web control

COMMAND CONTROL

administrator rights

setting.]

for all projectors to be

 

connected.

[Cannot apply

zzThe projector is in

BRIGHTNESS

standby status. Switch

CONTROL. Please

on the projector.

check projector status.]

 

 

zzThere is a problem with

 

the luminance sensor.

[Brightness Sensor

If the problem is not

corrected by turning off

Error]

the power and turning it

 

 

on again, consult your

 

dealer.

*1: “Multi Projector Monitoring & Control Software” is included in the attached CD-ROM.

Note

zzCheck the following when a projector to be connected is not listed.

–Is there a device on the network with the same IP address?

–Is a LAN cable connected correctly? ( page 126)

–Is the projector subnet identical?

–Is [LINK] set to the same group?

zzTo change a projector name, refer to [NETWORK SETUP] ( page 125), or [Network config] page ( page 133).

[PROJECTOR SETUP] menu

zzWhen [MODE] in [BRIGHTNESS

CONTROL SETUP] is [PC]

%5,*+71(66&21752/67$786

 

02'(

3&

 

 

 

352-(&725

 

 

 

 

 

 

0(18 5(7851

(1)Displays the name of the projector in question.

(2)Uses color to display status.

Green: There is margin for brightness correction.

Yellow: There is less margin for brightness correction.

Red: An error occurred in luminance control.

■■Example steps to adjust luminance control

The steps exemplify an adjustment to link the brightness of eight projectors connected in a network.

1)Use a LAN cable to connect all projectors to a hub. ( page 126)

2)Switch on all projectors.

3)Set [LAMP SELECT] to either [DUAL] or [SINGLE] for all projectors.

4)Set [MODE] in [BRIGHTNESS CONTROL SETUP] to [OFF] and [APPLY].

5)Set [SUBNET MASK] of the projectors to the same value, and [IP ADDRESS] of each projector to a different value so that the network can communicate.

6)Wait at least eight minutes until the lamp brightness becomes steady.

7)Set all items in the [PICTURE] menu of all projectors to the same values.

8)To match colors, adjust [COLOR MATCHING].

9)Display the internal test patterns of all projectors in “completely white”.

Settings

ENGLISH - 105