Operation Basic
Projecting
When a projection lens with a large weight is installed, or when the projector is installed in an inclination, the lens may tilt and the focus may become unbalanced. In these cases, refer to Figure 3 and the adjustment examples in the table below, and perform adjustments through the following procedures.
zzAdjustment procedure
1) Press the <FOCUS> button or the <LENS> button on the remote control on the control panel to display the focus adjustment menu.
2) Shift the focus of the entire screen once pressing ▼ .
3) Press ▲ to stop on any part of the screen to be the first just focus point.
zzFor the location where focus is shifted in this state, the just focus point is in the inner side of the screen.
4)Loosen the fixed screws in the position relative to the location where the focus is shifted the most (the location where the just focus point is shifted the most towards the inner side in Step 2)) up to two rotations (see Figure 3).
Attention
zzTurn screws clockwise in 2 locations, or at least in 1 location to be adjusted.
5) Little by little, turn the focus adjustment screws corresponding to the locations in the table below counter clockwise and stop where the image is in focus ( page 55). zzIf the screws are turned counter clockwise, the tilt of the lens will change (see Figure 1) by moving the lens
mount bracket of the lens mounter forward (screen side), and in the projected image on the screen, the adjustment screws and the focus point in the opposite direction will move from the inner side of the screen to the outside.
6) Press the <SHIFT> button on the remote control or the <LENS> button on the control panel to display the shift adjustment menu and reset the screen position of the projected image on the screen surface back to an optimal state.
7) Perform focus adjustment again near the center of the screen and if it is still not enough, fine tune the amount of rotation of the adjustment screws.
8) When adjustments have been made, securely tighten the loosened fixed screws.
9) Adjust the focus again using the remote control. zzTool used: Hex driver or allen wrench (diagonal 2.5 mm (0.1"))
zzThe allen wrench is included with the projection lens
Adjustment location:
Location where the just focus point of the screen is in the inner side of the screen
Figure 3 Relationship between the adjustment location and adjustment screws
56 - ENGLISH