2) Press ◀▶ to switch [WAVEFORM

MONITOR].

zzThe setting will change as follows each time you press the button.

[OFF][ON]

3)Press the <MENU> button two times to clear.

4)Press ▲▼ to select any horizontal

line.

zzItems switch as in the following diagram each time the <ENTER> is pressed while the waveform monitor is displayed.

“Select line (luminance)”

 

“Select line (red)”

“Select line (blue)” “Select line (green)” Note

zzThe [FUNCTION BUTTON] ( page 110) can also be used to set.

■■To adjust the waveform

Project the luminance adjustment signal of a commercial test disk (0% (0 IRE or 7.5 IRE) - 100% (100 IRE) ) and adjust.

[DISPLAY OPTION] menu

zzRed, green and blue adjustment

1) Set [COLOR TEMPERATURE] to [USER1] or [USER2]. ( page 66)

2) Select “Select line (red)” on the waveform monitor.

3) Adjust dark red areas.

zzUse [RED] in [WHITE BALANCE LOW] to adjust the black level 0% of the image signal to the 0% position of the waveform monitor. ( page 66)

4) Adjust bright red areas.

zzUse [RED] in [WHITE BALANCE HIGH] to adjust the white level 100% of the image signal to the 100% position of the waveform monitor. ( page 66)

5)Use the procedure for [RED] to adjust [GREEN] and [BLUE].

Note

zzBefore adjusting the black level for DVI-D signals, HDMI signals, and SDI signals, confirm that the [DVI SIGNAL LEVEL], [HDMI SIGNAL LEVEL], and [SDI SIGNAL LEVEL] settings are correct.

zzWaveform monitor cannot be displayed in [P IN P]. zzThe waveform monitor turns off when [P IN P] is

executed during waveform monitoring.

Signal level

Image displayable area

zzThe waveform monitor is not displayed when on- screen display is hidden (off).

zzTo display the waveform monitor in 3D image, use [3D WAVEFORM MONITOR]. (PT-DZ21KE and PT-DS20KE only)

Screen position

zzLuminance adjustment

1) Select “Select line (luminance)” on the waveform monitor.

2) Adjust black level.

zzUse [BRIGHTNESS] in the on-screen menu [PICTURE] to adjust the black level 0% of the image signal to the 0% position of the waveform monitor.

3) Adjust white level.

zzUse [CONTRAST] in the on-screen menu [PICTURE] to adjust the white level 100% of the image signal to the 100% position of the waveform monitor.

Settings

ENGLISH - 97