Panasonic PT-EZ580 PT-EW640 PT-EX610 PT-EW540 PT-EX510 [DIGITAL LINK STATUS], [NETWORK SETUP], When the projector is connected to a twisted-pair-cabletransmitter

Chapter 4 Settings — [NETWORK] menu

6)Press the <ENTER> button.

7)When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

Note

ff The projector does not support 10BaseT Full/Half.

1)Press as to select [DIGITAL LINK SETUP].

2)Press the <ENTER> button.

ff The [DIGITAL LINK SETUP] screen is displayed.

3)Press as to select [DUPLEX(DIGITAL LINK)].

4)Press qw to switch the communication method.

ff The items will switch each time you press the button.

[100BaseTX-Full]	Full-duplex communication method is set.
[100BaseTX-Half]	Half-duplex communication method is set.
[AUTONEGOTIATION]	The communication method is set automatically.

5)Press as to select [STORE].

6)Press the <ENTER> button.

7)When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

(Only for PT‑EZ580, PT‑EW640 and PT‑EX610) Display DIGITAL LINK connection environment.

1)Press as to select [DIGITAL LINK STATUS].

2)Press the <ENTER> button.

ff The [DIGITAL LINK STATUS] screen is displayed.

[LINK STATUS]	Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.
[HDCP STATUS]	Either [NO SIGNAL], [OFF], or [ON] is displayed.
	[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
	green, yellow, or red depending on that value.
	Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
	ff MAX/MIN: Maximum/minimum value of the amount of error.
[SIGNAL QUALITY]	ff Green (-12 dB or lower) → Normal signal quality level.
	ff Yellow (-11 to -8 dB) → Warning level where there is the possibility of noise introduced on the
	screen.
	ff Red (-7 dB or higher) → Abnormal level where synchronization may be interrupted or a signal may
	not be received.

Perform the initial setting of the network before using the network function.

1)Press as to select [NETWORK SETUP].

2)Press the <ENTER> button.

ff The [NETWORK SETUP] screen is displayed.

3)Press as to select an item, and change the settings according to the operation instructions of the menu.

	[PROJECTOR NAME]	Change the setting when using a DHCP server.
	[DHCP]	Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
	[DHCP]	using a DHCP server.
		using a DHCP server.
	[IP ADDRESS]	Enter the IP address when not using a DHCP server.

108 - ENGLISH