Chapter 3 Basic Operations — Operating with the remote control

ff Images may be disrupted for a few seconds during automatic adjustment, but it is not a malfunction. ff Adjustment is required for each input signal.

ff Automatic adjustment can be canceled by pressing the <MENU> button during the automatic adjustment operation.

ff If the automatic setup function is used while moving images are being input, the adjustment may not be performed properly even for an RGB signal that can use automatic setup. [INCOMPLETE] may appear, or adjustment may not be finished properly even if [COMPLETE] appears.

Using the keystone distortion correction function

The [KEYSTONE] menu can be displayed.

You can correct the keystone distortion that occurs when the projector is installed tilted or when the screen is tilted.

button

1)Press the <KEYSTONE> button.

ff The individual adjustment screen of [KEYSTONE] or [CORNER CORRECTION] ([UPPER LEFT]) is displayed.

2)Press the <KEYSTONE> button again.

ff The other individual adjustment screen is displayed.

When the [KEYSTONE] individual adjustment screen is displayed in Step 1), the [CORNER CORRECTION] individual adjustment screen ([UPPER LEFT]) is displayed.

Note

ff After the individual adjustment screen of [KEYSTONE] or [CORNER CORRECTION] is displayed, press asqw to adjust the keystone distortion.

ff Either setting of [KEYSTONE] or [CORNER CORRECTION] is enabled. If the other item is adjusted after [KEYSTONE] or [CORNER CORRECTION] was adjusted, the previous setting value will be reset.

ff If the <ENTER> button is pressed while the [CORNER CORRECTION] individual adjustment screen is displayed, the individual adjustment screen for the next corner is displayed.

ff Refer to the [POSITION] menu → [KEYSTONE] (x page 70) for details.

Using the digital zoom function

The [DIGITAL ZOOM] menu can be displayed.

You can enlarge images.

button

1)Press the <D.ZOOM> button.

ff The [DIGITAL ZOOM] screen is displayed.

2)Press qw to adjust the magnification.

3)Press the <ENTER> button.

4)Press asqw to move the zoom position.

Note

ff Refer to the [DISPLAY OPTION] menu → [DIGITAL ZOOM] (x page 84) for details.

Switching the aspect ratio of the image

You can switch aspect ratios according to the input signal.

button

1)Press the <ASPECT> button.

ff The setting will change each time you press the button.

Note

ff Refer to the [POSITION] menu → [ASPECT] (x page 68) for details.

54 - ENGLISH