Chapter 4 Settings — [PROJECTOR SETUP] menu

*3 When the Panasonic twisted-pair-cable transmitter (such as the optional Digital Interface Box (Model No.: ET‑YFB100G)) is connected to the projector, its input name is reflected from [INPUT1] to [INPUT10] automatically. If an item where the input name is not reflected is selected, it is disabled.

11)Press the <ENTER> button.

ff The command is fixed and n is displayed at the left of the selected command.

ff After the command is fixed, press the <MENU> button to close the detailed setting screen.

12) Press asqw to select [STORE], and press the <ENTER> button.

Note

ff If you attempt to register the setting that would make the lamp turn on for a short time during the same day, an error message will be displayed on the screen. Set the time and command again. If you set a schedule that would make the lamp turn on for a short time across two or more days, an error message will not be displayed. When executing a command for turning the projector on, provide an interval of at least four minutes between the [STANDBY] and the [POWER ON] command. When executing a command for setting the projector to standby, provide an interval of at least 31 minutes between the [POWER ON] command and the [STANDBY] command.

ff To delete a command already set, press the <DEFAULT> button on the remote control at the screen in Step 5), or select [DELETE] at the screen in Step 6) and press the <ENTER> button.

ff If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command number.

ff The operating time will be the local time. (x page 95)

ff If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in [SCHEDULE] is executed, the command set with this function may not be executed.

[STARTUP INPUT SELECT]

Set the input when the projector is switched on to start projection.

1)Press as to select [STARTUP INPUT SELECT].

2)Press the <ENTER> button.

ff The [STARTUP INPUT SELECT] screen is displayed.

3)Press asqw to select an input.

ff The items will switch each time you press the button.

[LAST USED]

 

Keeps the input selected last.

[VIDEO]

 

Sets the input to VIDEO.

[RGB1]

 

Sets the input to RGB1.

[RGB2]

 

Sets the input to RGB2.

[DVI‑D]

 

Sets the input to DVI‑D.

[HDMI]

 

Sets the input to HDMI.

[DIGITAL LINK] *1

 

Sets the input to DIGITAL LINK.

[DisplayPort] *1

 

Sets the input to DisplayPort.

[INPUT1] - [INPUT10]

*1*2

Sets the input to DIGITAL LINK, and switch the input of Panasonic twisted-pair-cable transmitter to

the specified input.

 

 

*1 Only for PT‑EZ580, PT‑EW640 and PT‑EX610

*2 When the Panasonic twisted-pair-cable transmitter (such as the optional Digital Interface Box (Model No.: ET‑YFB100G)) is connected to the projector, its input name is reflected from [INPUT1] to [INPUT10] automatically. If an item where the input name is not reflected is selected, it is disabled.

4)Press the <ENTER> button.

[RS-232C]

Set the communication conditions of the <SERIAL IN> terminal.

Setting the communication condition of the <SERIAL IN> terminal

1)Press as to select [RS-232C].

2)Press the <ENTER> button.

ff The [RS-232C]screen is displayed.

3)Press as to select [INPUT SELECT].

ff Only for PT-EZ580, PT-EW640 and PT-EX610. PT-EW540 and PT-EX510 are from step 5).

4)Press qw to switch the item.

90 - ENGLISH