Chapter 4 Settings — [SECURITY] menu

Attention

ff The initial password is “AAAA” by the factory default or when [ALL USER DATA] in [INITIALIZE] (x page 96) is executed. ff Change the password periodically that is hard to guess.

[CONTROL DEVICE SETUP]

Enable/disable the button operations on the control panel and the remote control.

1)Press as to select [CONTROL DEVICE SETUP].

2)Press the <ENTER> button.

ff The [CONTROL DEVICE SETUP] screen is displayed.

3)Press as to select [CONTROL PANEL] or [REMOTE CONTROL].

[CONTROL PANEL] You can set the limitation on the control from the control panel.

[REMOTE CONTROL] You can set the limitation on the control from the remote control.

4)Press the <ENTER> button.

ff The [CONTROL PANEL] screen or the [REMOTE CONTROL] screen is displayed.

5)Press as to select [ENABLE] or [DISABLE].

ff You can set the operation restriction from the control panel or the remote control.

[ENABLE]

Enables all button operations.

[DISABLE]

Disables all button operations.

6)Press the <ENTER> button.

ff The confirmation screen is displayed.

7)Press qw to select [OK], and press the <ENTER> button.

Note

ff When a button operation is performed on the device set to [DISABLE], the [MENU LOCK PASSWORD] screen is displayed. Enter the menu lock password.

ff The [MENU LOCK PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.

ff If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot enter standby).

ff When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main menu.

ff Even when you set button operations on the remote control to be disabled, operations of the <ID ALL> and <ID SET> buttons on the remote control are enabled.

106 - ENGLISH