Chapter 5 Maintenance — Maintenance/replacement

Replacing the unit

Lamp unit

The lamp unit is a consumable component. Refer to “When to replace the lamp unit” (x page 131) for details about the replacement cycle. When purchasing the optional Replacement Lamp Unit (Model No.: ET‑LAE300), consult your dealer.

It is recommended that you request a qualified technician to replace the lamp unit. Consult your dealer.

Warning

Replace the lamp unit after the lamp has cooled (after waiting at least one hour).

The high temperature inside the cover will cause burns.

Notes on the replacement of the lamp unit

ff A Phillips screwdriver is necessary when replacing the lamp unit.

ff Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object. Handle with care. ff Do not disassemble or modify the lamp unit.

ff When replacing the lamp unit, be sure to hold it by the handle because its surface is pointed and its shape is protruded.

ff The lamp may rapture. Replace the lamp unit carefully so the glass fragments of the lamp do not scatter. While attaching the projector to the ceiling, do not work right under the lamp unit or do not conduct work while your face is near the lamp unit.

ff The lamp contains mercury. When disposing of used lamp units, contact your local authorities or dealer for correct methods of disposal.

Attention

ff Panasonic takes no responsibility for any damage or malfunction of the product resulting from use of lamp units which are not manufactured by Panasonic. Use only specified lamp units.

Note

ff The model numbers of accessories and optional accessories are subject to change without prior notice.

When to replace the lamp unit

The lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary to replace the lamp unit regularly. The estimated duration before replacement is 4 000 hours, but the lamp may go off before reaching to 4 000 hours, depending on the characteristics of the individual lamp, usage conditions, and the installation environment. It is recommended that the Replacement Lamp Unit be prepared earlier.

If you continue to use the lamp unit after 4 000 hours has elapsed, the lamp turns off automatically after approximately 10 minutes, as it may cause malfunction of the projector.

 

On-screen display

Lamp indicator

 

REPLACE LAMP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Over 3 800 hours

The message is displayed for 30 seconds. Pressing

 

 

 

 

 

 

any button on the control panel or remote control

The indicator lights in red even during the standby

 

within 30 seconds will clear the message.

 

mode.

Over 4 000 hours

The message remains displayed until you press any

 

 

 

 

 

 

button.

 

 

 

 

 

 

 

 

 

 

 

 

 

Note

ff To predict when to replace the lamp, check the lamp runtime displayed at [LAMP : TOTAL] in [STATUS] (x page 94). ff 4 000 hours is only the target for replacement and not the warranty time.

How to replace the lamp unit

Attention

ff While attaching the projector to the ceiling, do not work right under the lamp unit or do not conduct work while your face is near the lamp unit.

ff Do not remove or loosen the screws other than specified ones when replacing the lamp unit. ff Make sure to attach the lamp unit and the lamp cover securely.

ENGLISH - 131