Chapter 1 Preparation — About your projector

Attention

ff Do not drop the remote control.

ff Avoid contact with liquids or moisture.

ff Do not attempt to modify or disassemble the remote control.

ff Please observe the following contents that are described on the back of the remote control unit (see the right picture).

1.Do not use a new battery together with an old battery.

2.Do not use unspecified batteries.

3.Make sure the polarities (+ and -) are correct when inserting the batteries.

ff In addition, please read the contents that are related to batteries in the "Read this first!".

1.Do not use old battery with new one.

2.Do not use batteries other than the

type specified. 3.Be sure the batteries are inserted properly.

Made in China

Note

ff When operating the remote control by directly pointing the remote control signal receiver of the projector, operate the remote control at a distance approx. 30 m (98'5") or shorter from the remote control signal receiver. The remote control can control at angles of up to ±30° vertically and horizontally, but the effective control range may be reduced.

ff If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly. ff The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material. ff If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use

it in a place distant from the light source.

ff The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.

Projector body

Front

 

Side

 

 

1 2 3 4 5

6

7

8

6

Rear

9

10

11

12

13

14

15

Projection direction

WARNING

Keep your hands and other objects away from the air exhaust port.

ff Keep your hands and face away. ff Do not insert your fingers.

ff Keep heat-sensitive objects away.

Heated air from the air exhaust port can cause burns, injury, or deformations.

1 Remote control signal receiver (front)

2Power indicator <ON (G)/STANDBY (R)>

Displays the status of the power.

3Lamp indicator <LAMP>

You can display the status of the lamp.

16 15

179

4Temperature indicator <TEMP>

Displays the status of the internal temperature.

5Filter indicator <FILTER>

Displays the status of the air filter unit.

6Adjustable feet

Adjusts the projection angle.

7Speaker

8Projection Lens

(Only models with lens)

9Air exhaust port

10Remote control signal receiver (rear)

11<MAIN POWER> switch

Turns off/on the main power.

12<AC IN> terminal

Connect the supplied power cord.

24 - ENGLISH