Panasonic PT-L6510U manual Starting to use, Leveling the Projector

Starting to use

Leveling the Projector

For the best viewing result free from distortion, the projector should be carefully leveled on its base. Follow the steps below to correct the tilt angle of the projector when it is installed on a floor-standing base.

1.While lifting and holding the front side of the projector to the level position, pull and hold the LEVELING button on each side of the bottom panel until the leveling feet rest on the projector base surface.

LEVELING Lever	LEVELING feet
on each side.

<Retracting the Leveling Feet>

While lifting the front side of the projector, raise the Leveling lever, and then slowly lower the unit.

Caution

•Do not press the LEVELING levers without holding the projector with your hands. Otherwise, the leveling feet will be unlocked and the projector may drop rapidly onto the projector base surface, possibly leading to damage.

Caution

•Keep holding the projector until both leveling feet touch the base surface.

2.Release the LEVELING levers.

The leveling feet lock in place.

3. Make fine leveling adjustments by manually turning the leveling feet.

47 mm

Note

•The maximum length of the leveling foot is 47 mm. If it is rotated on reaching that length it will turn freely without extending further.

•If the picture has keystone distortion, do keystone adjustment from the menu. (page 32)

Adjusting the Vertical Position of

the Picture

The vertical position of the picture can be adjusted using the electric “LENS SHIFT” buttons on the rear control panel. Do this adjustment after the projection distance and projector position have been determined.

•Adjusting vertical position with the “LENS SHIFT” buttons:

Press the button to shift the picture upward.

Press the button to shift the picture downward.

•Adjusting vertical position from the menu: Alternatively, you can adjust the vertical position of the picture by choosing the “LENS SHIFT” option from the “OPTION 1” menu chosen from the MAIN MENU (see page 34).

Caution

When shifting the lens, be careful not to catch your fingers between the lens and shroud.

24