Panasonic PT-L6510U manual Cleaning and replacing the air filter, Cleaning method

Cleaning and replacing the air filter

If too much dust accumulates in the air filter, the temperature inside main unit will become high.

•With the PT-L6510U, the temperature sensor (TEMP) lamp will flash.

•With the PT-L6600U, the temperature sensor (TEMP) lamp will flash and the light source lamp will go out. Clean the air filter approximately every 100 hours of use, although more frequent cleaning may be necessary depending on the environment.

Cleaning method

1. Turn the Main Power off and remove the power plug.

Turn the power off by following the steps on page 23, and remove the power plug.

2. Remove the air filter cover.

Remove the air filter cover by pushing down on the tab and pulling forward.

OUT

IN

SE

RIA

L

IN

OUT

R

IN

USB

REM

O

L

IO

T

OUT

GB OU

RGB

AUD

R

> PC

IN

IN

AUDIO

DIO

IN

AU

RG

B 2

VID

EO

VD

D

EO

IN

SYNC

/H

S-VID

B/B

-Y/PB

1

IN

G/Y

R

GB

OU

T

R/R-Y/P

R

DVI-D

IN

3. Clean the air filter.

Remove accumulated dust using a vacuum cleaner.

Notch

Caution

•Be careful not to suck the air filter into the vacuum cleaner.

Air filter

4. Attach the air filter and cover.

Place an air filter inside the air filter cover, and replace the cover by reversing the step described in (2).

Caution

•Place the air filter aligning the notch toward the upper right direction.

•Do not operate the projector without the air filter.

If the projector is operated without the air filter, dust will enter the unit and may cause a malfunction.

Note

•If dust cannot be removed with a vacuum cleaner, it is time to replace the filter. Please consult your dealer. Replace the air filter when replacing the lamp unit.

41