Panasonic PT-L6510U manual Using the SERIAL, Control command, Cable specifications, USB contorol

Using the SERIAL

Control command

When controlling the projector using a computer, commands are as follows:

Command	Control contents			Remarks
PON	Power ON	During standby mode, commands other than PON are invalid.
		• While the lamp is ON and being controlled, the PON command is invalid.
		• After turning the lamp OFF, if the PON command is sent during cooling fan
POF	Power OFF	operation, lighting control will function for approximately 95 seconds (PT-
		L6510U) or 40 seconds (PT-L6600U) after turning OFF to protect the lamp.
		Parameter
AVL	Volume	000 = Adjustment value 0
		063 = Adjustment value 63
AMT	Mute (audio mute)	Parameter
		0 = Mute (audio mute) off			1 = Mute (audio mute) on
IIS		Parameter
	Switch input modes	VID = VIDEO	SVD = S-VIDEO
		RG1 = RGB1	RG2 = RGB2		DVI = DVI
ORF	Switch RGB 1 · 2 input signals	Parameter
		0 = RGB	1 = YPBPR		(Only 1080i input)
Q$S		Parameter
	Check lamp lighting condition	0 = Standby	1 = Lamp lighting control
		2 = Lamp lit	3 = Lamp off control
		Parameter
QLS	Check lamp lighting condition	0 = Lamp 1 and 2 off		1 = Lamp 1 on
		2 = Lamp 2 on		3 = Lamp 1 and 2 on
OSI	SET ID	Parameter
		0 (ALL) to 99
OFZ	Freeze	Parameter
		0 = Freeze off	1 = Freeze on
OMN	Menu
OEN	Enter
OCU	Cursor up
OCD	Cursor down
OCL	Cursor left
OCR	Cursor right
OAS	Auto setup
OSH	Shutter
DZU	D.Zoom up
DZD	D.Zoom down
FC1	Function 1

Cable specifications

< Connecting to a computer >

Caution

•Purchase an appropriate communication cable to connect a computer to the serial terminal.

			Computer
Projector		(DTE specifications)
1	NC	NC	1
2			2
3			3
4	NC	NC	4
5			5
6	NC	NC	6
7			7
8			8
9	NC	NC	9

USB contorol

The same control as RS-232C can be performed using USB. Need to prepare device driver and control software.

38